Is the baud rate of the projector changeable?
No. The default baud rate is 9600 and cannot be changed.
Which types of BenQ projectors require a power cycling process?
For BenQ projectors designed for general home entertainment and business use, we recommend powering off the projector for 2-3 minutes after every 12 hours of constant use for longer lasting reliability and maximized projector lifespan.
BenQ professional projectors designed with corresponding industrial standards can be used continuously for more than 12 hours and do not require a power cycling process as our home and general-use business projectors do.
If you have any questions, please contact your local BenQ customer care team for further assistance. Thank you.
My remote control is not working. What can be done to fix it?
Please follow below steps for troubleshooting:
(1) Check if the remote receiver is turned off by accident in OSD. It should be turned to Front/Top/Front+Top.
(2) Check if the batteries are out of power. Replace both of the batteries with new ones.
(3) Make sure you are not too far away from the projector. Stand within 7 meters from the projector.
(4) Remove the obstacles between the remote control and projector.
For demo, please refer to the tutorial video
May I know the version of DisplayPort of LU9715?
The version of LU9715 DisplayPort is 1.1a.
How does LU9915 3D sync in/ out feature work with other device?
3D sync in is for some scenarios that need to link two or more projectors for displaying 3D content. It can receive the 3D sync. signal from the source (ex. computer’s display card) or another projector.
For example, multiple projectors to display a blended (extended to wider screen) 3D picture, the projectors needed to be synchronized.
Or for using 2 projectors to display one 3D picture (overlapped for brighter picture) and each projector is responsible for one eye’s picture (one for right eye and one for left eye).
Can I control the BenQ projector with a remote control designed by other manufacturers?
Yes. When setting the remote control, please input the [custom code + IR code] or [IR code + custom code] based on the instruction on the remote control.
The custom code for BenQ is 0X30. For IR code, please refer to the user manual.
Which reminder messages will stop being displayed after "Reminder Message" is switched off?
After "Reminder Message" option is switched off in OSD, the following messages will stop being displayed:
- All signal searching…
- No signal
- (Source) Source searching…
- (Source) Source detected
- Auto adjusting…
- Signal status(Source information menu)
- ECO BLANK/No source detected
- Out of range
- Best resolution
How to use 3D sync out connector?
There are two types of 3D sync out connectors. For the steps to use 3D sync out connectors, please refer to the tutorial video.
Every time when projector powers on, the power LED will flash in orange for around 10 seconds then be solid red. Is it normal?
It is normal. When the standby Mode setting is "Network", the power LED will be flashed till the power supply is stable.
In OSD display, there is pincushion/ barrel option. May I know what is it?
When you select pincushion/barrel in OSD, then press direction key, you will see the image to become pincushion or barrel.
When you press right key (value>0), the image will be in barrel shape.
When you press left key (value<0), the image will be in pincushion shape.
Is LU9715 equipped with ID SET feature for remote controller?
Units manufactured after Aug., 2016 are equipped with this feature. Please contact with local BenQ authorized service center for firmware upgrading if your LU9715 is without this feature.
How do I clean my projector lens?
Please refer to the below video for a guide to cleaning your projector's lens.
How to change the lamp and reset the lamp timer?
Please refer to the below video for instructions on how to replace a projector lamp and reset the lamp life timer on BenQ projectors.